Psalm 29 reassures us the God is both powerful and in control. He sits enthroned above the flood.
Firstly, get the Noah's Ark and animals transferred onto white felt by the sublimation printing and heat press method - see my post on Sublimation Printing on Felt - Test. Cut out the ark and animals and sew the ark onto the background page along three sides leaving the top open to form a pocket for the animals.
Prepare two wooden cloud buttons by threading 15cm of the elastic onto each and tying a knot to create a loop of elastic. Slide the knot to the back of the button and hot glue in place. Cut the ends short.
Cut your mesh material to size to fit inside your page with extra length (and width if you want to finish the edges first - I didn't but I wish I had). Fold the top over itself a couple of times and pin and sew along the top edge as shown above, placing the elastic of the buttons underneath at either end. Make sure the end is poking out the bottom so you can pull it up and over the buttons to hold the rolled up mesh in place later.
Measure your ground and make a few layers of grass for the animals to sit in. I used ric rak to edge the top of the grass as there would be too many layers of felt along the bottom if I doubled the felt as I usually do. Use kam snaps to attach the grass to the page. At the back, use small squares of spare felt to strengthen them and prevent them ripping a hole when being pulled.
Cut a length of rainbow ribbon to fit your page and melt the edges - see my post on How to Stop Ribbons Fraying. I rounded the edges, but you don't have to. Mark where the button holes should be on the ribbon, then sew and cut.
Use the a colouring page as a throne template to make your throne. Simplify the lines by joining some together and rounding off the top.
Before sewing the pleather, I used the glue to attach the pleather to a sheet of felt. My pleather was stretchy which makes it very difficult to sew. Allow the glue to dry before sewing in place. Then sew the red felt on top and cut out the front section of the throne. Decorate with beads at the top.
Make a slot for threading the throne onto the rainbow ribbon by doubling a piece of felt and sewing onto the other half of your sheet of felt. Make sure it is slightly wider than your rainbow ribbon to allow it to pass through easily. Hot glue the throne to the sheet of felt with the slot facing out and centered at the back. Cut out the throne once again.
Thread the throne onto the ribbon and button it on, or store in the ark pocket.
Complete!
This Psalm speaks about God twisting the oaks and breaking the cedars. Trees are often used as a symbol of men and strength. So the strength of men is nothing to God. Therefore, why worry about what man can do to you? Rather worry about pleasing God.
Not only does God rule over the kaos of The Flood, but He caused it.
Memory Verse: “The Lord sits enthroned over the flood; the Lord is enthroned as King forever." Psalm 29:10 NIV
Materials needed to create the Enthroned Above The Flood quiet book page:
- A4 felt background sheet - I used blue
- a Noah's ark and animals image - I used this printable from the article Sharing Time: The Prophet Will Tell Us in the LDS kids magazine Friend
- felt in white, green, red and as close as you can get to gold
- Kam snaps
- ric rak
- 30cm of 2mm round elastic
- wooden cloud buttons - I bought these from AliExpress (not an affiliate link)
- dotted mesh material
- 40mm wide rainbow ribbon - I bought this from AliExpress (not an affiliate link)
- gold pleather
- clear craft glue if using pleather to make sewing easier - I used polyacetic acid & ethylene resin based glue
- decorative beads
- a throne template - I modified this Colouring page Saint Nicholas' throne from edupics.com
- hot glue gun and glue
Firstly, get the Noah's Ark and animals transferred onto white felt by the sublimation printing and heat press method - see my post on Sublimation Printing on Felt - Test. Cut out the ark and animals and sew the ark onto the background page along three sides leaving the top open to form a pocket for the animals.
Prepare two wooden cloud buttons by threading 15cm of the elastic onto each and tying a knot to create a loop of elastic. Slide the knot to the back of the button and hot glue in place. Cut the ends short.
Cut your mesh material to size to fit inside your page with extra length (and width if you want to finish the edges first - I didn't but I wish I had). Fold the top over itself a couple of times and pin and sew along the top edge as shown above, placing the elastic of the buttons underneath at either end. Make sure the end is poking out the bottom so you can pull it up and over the buttons to hold the rolled up mesh in place later.
Measure your ground and make a few layers of grass for the animals to sit in. I used ric rak to edge the top of the grass as there would be too many layers of felt along the bottom if I doubled the felt as I usually do. Use kam snaps to attach the grass to the page. At the back, use small squares of spare felt to strengthen them and prevent them ripping a hole when being pulled.
Cut a length of rainbow ribbon to fit your page and melt the edges - see my post on How to Stop Ribbons Fraying. I rounded the edges, but you don't have to. Mark where the button holes should be on the ribbon, then sew and cut.
Use the a colouring page as a throne template to make your throne. Simplify the lines by joining some together and rounding off the top.
Before sewing the pleather, I used the glue to attach the pleather to a sheet of felt. My pleather was stretchy which makes it very difficult to sew. Allow the glue to dry before sewing in place. Then sew the red felt on top and cut out the front section of the throne. Decorate with beads at the top.
Make a slot for threading the throne onto the rainbow ribbon by doubling a piece of felt and sewing onto the other half of your sheet of felt. Make sure it is slightly wider than your rainbow ribbon to allow it to pass through easily. Hot glue the throne to the sheet of felt with the slot facing out and centered at the back. Cut out the throne once again.
Thread the throne onto the ribbon and button it on, or store in the ark pocket.
Complete!
Difficulty Level = Intermediate.
Pleather can be difficult to work with.
Key Learning Areas and Skills
- Psalm 29 - God is in control even when it might seem like He is not
- Rolling - roll up the rain, and roll it down again
- Buttoning - secure the rain when it is rolled up with the elastic and cloud buttons, button on the rainbow ribbon
- Threading - thread the throne onto the rainbow ribbon
- Colours - learn the colours of the rainbow
- Tucking - tuck the animals into the ark
- Using snaps - snap on and off the ground to make it appear to flood
- Fine Motor Skills - all quiet books encourage fine motor skill development
- Hand-eye Co-ordination - all quiet books encourage hand-eye co-ordination
Read the Chapter
Psalm 29.Devotional
Maybe you feel like everything is out of control, but God assures us that He's got it. Sometimes trouble is what we need to wake us up and turn our course. When trial comes are we willing to listen to instructions and build an ark? Or do we insist on our own way?This Psalm speaks about God twisting the oaks and breaking the cedars. Trees are often used as a symbol of men and strength. So the strength of men is nothing to God. Therefore, why worry about what man can do to you? Rather worry about pleasing God.
Not only does God rule over the kaos of The Flood, but He caused it.
Psalm 29 - HeartSong
Lindo!
ReplyDeleteParabéns